Katy, TX · Houston MetroMon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET

Home › Services › Flat & Commercial Roofing

Flat & Commercial Roofing in Katy, TX

A flat roof is not flat — it is low-slope, and the slope is what moves water to the drains. The covering is a membrane, not shingles: a single sheet or welded seams that seal the whole field, with drains, scuppers and edge details doing the work that a steep slope does by gravity. When the membrane, the seams and the drains are right, a low-slope roof stays dry through a Houston downpour.

Call Now

Talk to a local roofing professional

One call connects you with a local professional for the Houston metro. Describe your roof — what you are seeing, and where — and the visit is arranged from there.

Call Now

Mon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET

1
Inspection firstEvery visit starts by looking at the roof, not by guessing from the ground.
2
Storm damage coveredHail, wind and hurricane damage — inspected and documented step by step.
3
Local to the metroKaty, Houston and nine more metro communities, with local detail on every page.
4
One callCall Now connects you with a local roofing professional for your area.
Understanding flat & commercial roofing

How flat & commercial roofing works in Houston metro homes

Low-slope membranes come in a few main types, and each seals differently. A single-ply membrane is a wide sheet welded at the seams; a built-up roof is layers of felt and bitumen; a modified bitumen roof is a rolled sheet with a mineral surface. The type on your building decides how it is inspected and repaired — a welded seam is checked by pulling at it, a built-up roof by looking for blisters and cracks in the surface.

Ponding water is the quiet problem on low-slope roofs. Water that stands for days after a rain means the slope has settled or a drain is blocked, and standing water works at the seams and the membrane every hour it sits there. The inspection notes where water stands and how long it stays, because the fix may be a drain, a tapered section, or a membrane repair — three different answers to one puddle.

Penetrations are where low-slope roofs leak. Every rooftop unit, vent pipe and skylight cuts the membrane, and each cut is sealed with flashing and sealant that age in Houston heat. The inspection checks every penetration, because a roof with a sound field and ten tired penetrations is a roof that leaks in ten places.

  • Whole field walked — membrane, seams, blisters and cracks checked
  • Drains and scuppers cleared and tested, so water leaves the roof
  • Every penetration checked — rooftop units, vents, pipes and skylights
  • Ponding water noted, with the cause traced to slope or drain
  • Edge and parapet details checked, where wind lifts the membrane
Flat & Commercial Roofing in Katy, TX
What the service includes

What flat & commercial roofing includes

Membrane inspection

The field is walked and the membrane checked for blisters, cracks, worn spots and open seams. The membrane type decides the test — welded seams are pulled, built-up surfaces are looked at for cracking.

Seam repair

Open or failed seams are cleaned and re-welded or patched to the membrane type, so the seal is continuous across the field again.

Drain and scupper work

Drains are cleared and tested, scuppers are checked for blockages, and the slope to each drain is looked at so water runs off instead of standing.

Penetration flashing

Flashing and sealant around rooftop units, vents and pipes are renewed where heat has cracked them. Each penetration is sealed to the membrane it cuts.

Ponding water plan

Where water stands after rain, the cause is traced — settled slope, blocked drain, or a low spot — and the plan names the fix for that cause.

Maintenance schedule

A low-slope roof is inspected on a schedule, not when it leaks. The visit notes set the rhythm — after storm season, and after the summer heat.

How it works

The visit, step by step

1

Call and describe the building

Say what the building is, the roof size and age, and what you are seeing — ponding water, a leak inside, or a roof that has not been looked at in years.

2

Full-field inspection

A local professional walks the whole field, checks seams, penetrations, drains and edges, and notes where water stands after rain.

3

Repair and maintenance plan

The plan names the membrane work, the drain work and the penetration work, and sets the inspection rhythm for the roof.

4

Membrane and drain work

Seams are repaired, drains are cleared and tested, and penetration flashing is renewed as the plan sets out.

5

Scheduled check

The roof is checked on the schedule agreed — after storm season and after the summer heat — so small problems are caught before they leak.

Tools & methods

How the work is done

A low-slope inspection is done on foot, walking the whole field in a grid so no area is missed. The inspector looks for blisters that mark trapped moisture, cracks in the surface, and seams that have opened at the edge. Each finding is marked on the roof plan, so the repair crew goes to the right place.

Seam work is done with the membrane dry and clean. A welded seam is heated and rolled until the bond is continuous; a patch is cut larger than the damage and welded on every side. A seam patched in the rain or over dirt will open again at the next storm.

Drains are tested with water, not just looked at. A drain that looks clear can still run slowly if the pipe below is blocked, and slow drainage is ponding water by another name.

Before the visit

Note the roof material, its rough age, and what you are seeing — where the problem shows inside, and when it started. The inspection follows your evidence, so the notes help more than a climb ever will.

Call Now

Signs to watch

Signs you need flat & commercial roofing

Water standing on the roof days after a rain, a leak that shows under a rooftop unit, blisters or bubbles in the membrane surface, and sealant cracking around vents are the signs a low-slope roof needs a look. Inside, a stain on the ceiling below a penetration usually means the flashing at that penetration has aged out.

The sign that matters most is the one the roof keeps quiet about: a seam that has opened a little, letting water under the membrane where it soaks the insulation and the deck. The field can look sound while the layers beneath are wet — which is why the inspection walks the field and tests the seams, rather than looking from the edge.

Houston weather

Flat & Commercial Roofing and the Houston climate

Houston weather is hard on low-slope roofs. Heavy rain tests the drains, hurricane wind lifts the membrane at the edges and parapets, and summer heat cracks the sealant around every penetration. A low-slope roof here is inspected on a schedule that follows the storm calendar, not when the ceiling stains.

Heat is the slow test. A membrane that sits in standing water under a summer sun ages faster than a membrane that drains, and sealant around penetrations cracks a little more each summer. The maintenance rhythm — checked after storm season and after the heat — is what keeps a low-slope roof dry year after year.

Before & after

Problem → solution

Problem

A Katy warehouse with a low-slope roof: water standing near the drains after every rain, and a leak showing under a rooftop unit in the office below.

→

Solution

The inspection found two blocked drains and cracked sealant around the rooftop unit. The drains were cleared and tested, the unit flashing was renewed, and a scheduled check was set for after the storm season.

Problems solved

Problems flat & commercial roofing solves in the Houston metro

Ponding water

Water that stands after rain works at the seams. Tracing the cause — slope or drain — names the fix.

Open seams

A seam that has opened lets water under the membrane. Re-welding the seam restores the seal.

Penetration leaks

Rooftop units and vents cut the membrane. Aged flashing at the cut is the most common leak source.

Edge lift

Wind lifts the membrane at edges and parapets. Edge details are checked as part of every inspection.

Questions

Frequently asked questions

Straight answers to the questions Houston metro homeowners ask most.

A flat roof is low-slope, so it uses a membrane that seals the whole field, with drains moving the water off. A shingle roof is steep-slope, so gravity moves the water. The two need different inspections and different repairs.

A settled slope, a blocked drain, or a low spot in the field. The inspection traces the cause, because the fix depends on it — a drain, a tapered section, or a membrane repair.

On a schedule — after storm season and after the summer heat — not only when it leaks. The visit notes set the rhythm for your roof.

A membrane with local damage is repaired. A membrane worn across the whole field, or with wet insulation beneath it, is a replacement conversation. The inspection gives the read for your roof.

The flashing and sealant where the unit cuts the membrane, the curb the unit sits on, and the drain path around it. A rooftop unit is a penetration, and penetrations are where low-slope roofs leak.

Flat & Commercial Roofing problem in Katy?

Call now — we will connect you with an independent local roofing professional for an inspection and a clear plan for flat & commercial roofing.

Call Now
Contact

Talk to a local roofing professional

One call connects you with a local professional for Katy, Houston and the metro around them. Describe your roof — what you are seeing, where the problem shows, and when it started — and the visit is arranged from there.

Call Now

Mon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET

Service area

Katy · Houston · Sugar Land · Cypress · The Woodlands · Pearland · Spring · Pasadena · Humble · Kingwood

Houston Roofing Pros is a referral service connecting customers with local roofing professionals; it is not itself the service company.

☎ Call Now
Houston Roofing Pros